Radio Shack Easy Remote Specifiche Pagina 11

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 46
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 10
The red indicator light blinks twice to indicate the punch-through
feature is on.
IF YOU HAVE PROBLEMS:
MANUAL CODE SEARCH:
If the 6-in-1 Remote Control does not operate your remote controlled
devices when you first set it up, you may have to find the code for your
devices. You can try all the codes listed in the "Manufacturer's Codes"
section for the brand of your device. You can also search the 6-in-1
Remote Control's entire library by following these steps.
1. Manually turn on the device you want to set up and press the
corresponding device key on your 6-in-1 Remote Control (TV, VCR, CBL, CD,
and so on)
2. Aim the 6-in-1 Remote Control at the device you want to operate.
3. Press and hold SET UP until the red indictor light blinks twice.
Release SET UP and press 9 - 9 - 1. The red indicator light blinks twice
again.
4. Slowly alternate between PWR and the device key.
For example, if you are searching for the code to operate your TV, use
the following sequence.
SET UP - 9 - 9 - 1 - PWR - TV - PWR - TV - PWR...
Each time you press the TV key, the remote control advances to the next
manufacturer's code in the library.
5. When your device responds, immediately press SET UP to lock in the
manufacturers' code.
Note:
Because of the large number of codes in the 6-in-1 Remote Control's
library, this procedure can take several minutes. If your device turns
off during the search, but will not operate after you lock in your code,
begin the search again, pausing longer between key presses.
If necessary, repeat these steps for each device.
DETERMINING THE 3-DIGIT CODE:
Vedere la pagina 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 45 46

Commenti su questo manuale

Nessun commento